Bloom Cream Jumbo Refill Pod InstructionsUpdated 21 days ago

Are you ready to insert your Bloom Cream Jumbo Refill Pod?! Follow the steps below. 

Refill Instructions: 
Step 1: Unscrew the top of your Bloom Cream Jumbo  
Step 2: Pull out the empty pod and recycle (check that the piston from the bottom of the pod has not attached itself to the underneath of the dispenser top, if it has, remove this piece)
Step 3: Remove the seal from your Refill Pod 
Step 4: Place pod at the base of your Bloom Cream Jumbo 
Step 5: Screw top back on and press actuator to bloom your cream 

**Helpful Tip** 
Sometimes the piston from the original pod suctions to the underneath of the dispenser top at the end of it's use. The piston is a wheel shaped piece that sits at the bottom of the pod and is the part of the mechanism that moves the product up when it's being dispensed. Kind of like a push-pop.

Please re-open your Jumbo Bloom Cream and check to see if the piston is suctioned to the underneath of the dispenser top or if it may have fallen off into the new pod when it was pressed down. Remove this piece, screw the top back on and give the mechanism a few presses to prime. 

**Please note that Refill Pods were designed to work with Bloom Cream Jumbos purchased after 4/23/24. If your jumbo size Bloom Cream was purchased before 4/23/24, you'll need to purchase a newer Bloom Cream Jumbo before using the refill. 

Once complete, you can recycle your Bloom Cream packaging and other Beekman 1802 skincare and bodycare product packaging through our Neighbor Recycling Program!